|
Spray Tip Description |
Spray Tip Pattern NOTE - based on tip being at a right angle six inches from the surface being sprayed |
|
110° Flat Fan |
15 x 2 rectangle If the tip is angled the pattern will be larger. |
|
80° Flat Fan |
11 x 2 rectangle |
|
50° Flat Fan |
8 x 1-3/4 rectangle |
|
25° Flat Fan |
4 x 1 rectangle |
|
TK1.5 Deflected Fan |
90° Fan pattern that sprays out the side of the nozzle |
|
TG2 Full Cone * |
5 Round (with pump set at full lubrication volume Orifice opening is 0.047 inches) |
|
TG1 Full Cone * |
4 Round (with pump set at 3/4 lubrication volume Orifice opening is 0.036 inches) |
|
TG0.7 Full Cone * |
2 Round (with pump set at 1/2 lubrication volume Orifice opening is 0.030 inches) |
|
TG0.5 Full Cone * |
1 Round (with pump set at 1/4 lubrication volume Orifice opening is 0.024 inches) |
|
TG0.3 Full Cone * |
1/2 Round (with pump set at 1/8 lubrication volume Orifice opening is 0.020 inches) |
|
0.0003 Pinpoint |
1/2 Round (with pump set at ½ or greater lubrication volume Orifice opening is 0.047 inches) |
|
0.0001 Pinpoint |
1/4 Round (with pump set at less than 1/2 lubrication volume Orifice opening is 0.028 inches) |
* NOTE - Cone pattern spray tips should NOT be used in an application where a straight oil is being used. The design of the cone pattern tip does not allow straight oil to dispense in a swirling motion creating a stream of fluid rather than a circle pattern. The factory recommends using a fan tip with straight oils.
NOTE - Lower section of menu has Technical Information page links
Modular Components - High
Viscosity Pump, Standard Pump Cut-Away & Solenoid (buy
with or without remote tank)
Systems - One to 12 Pump
(Micro-Flex, Min-Flex, ...)
Systems - One to Two Pump Mod Flex - NEW 2003
Maintenance, Pump Information, ...
Pump Part Identification Drawing &
List
Pump Picture - View Details via Cut-away of Standard & Micro Pump
Tip Selection - See the spray pattern for the
various tips
THE FLEXSPRAY PISTON-PUMP BODY GUARANTEE:
The pistons and pump bodies on all FlexSpray pumps are guaranteed against failure due to cylinder bore scoring or material defects or workmanship, during normal use, for as long as the pump assembly continues to be in active service under the same application and design criterion initially intended. Upon submission of a defective piston, pump body or both, FlexSpray or one of its distributors will provide a replacement piston and/or pump body of the same size and specification, with out cost to the end user.
E-Mail: Info@chpsystemsinc.com
Voice (423)318-8334 Facsimile: (423)581-7469
CHP Systems, Inc. - 3007 Arrow Dr. Morristown, TN 37814